This page may contain affiliate links. If you click and buy, I may earn a small commission at no extra cost to you. Your purchase using affiliate links helps support the creation of independent content.
I get a lot of request for the older content so I am putting this one back up. It is old and outdated. Back in the early days of Polymer80, we used to get mill bits with our kit and this was the original way to do the frames. This method has long been abandoned but it kind of know to know how far we have come.
If you are looking for the newest methods, check out Freedom Crew University where we teach the newest methods. My good buddy Marine Gun Builder has an excelent course out there including the newer “Bridge Frame”.
If you want to learn more about the tools used in the PF940SC Videos visit https://trb.fyi/tools-used-in-the-polymer80-pf940sc-completion-videos/. If you need more information about troubleshooting visit our Glock Troubleshooting Guide at https://trb.fyi/glock-troubleshooting-guide/
This content shows an older method for completing a Polymer80 PF940SC using a Dremel. While it may still be helpful for historical reference, it does not reflect current best practices or legal considerations.
Looking for current info?
➤ Check out updated PF940SC courses at Freedom Crew University.
➤ See tools used in the original videos: PF940SC Tools List
➤ Need help troubleshooting your build? Read our Glock Troubleshooting Guide
Video index:
Recommendation – 0:16
What’s included – 0:41
Basic steps – 1:09
Drilling the frame – 1:36
Cutting the frame – 2:55
Cutting the barrel block – 4:31
Installing the magazine release – 7:19
Installing the rails – 8:15
Installing the trigger – 9:44
Installing the takedown – 12:03
Does it work? – 13:07