PF940sc Tools used post image
Spread the love

Tools used in the Polymer80 PF940SC completion videos

In this post, we will show you what tools we used in our PF940SC completion video and when we used them. 

Since I used the Glock 26 from our disassembly and reassembly videos the only thing that I needed to purchase was the PF940SC which I got from Brownells.

PF940SC Completion – Dremel Method

Drilling the frame

4 1/2″ Vice – Hold the Frame and Jig

Vice Jaws – Hold the Frame and Jig

Ryobi drill

Hobby Knife – Clean up extra plastic

Cutting the frame with nips and a Dremel

    4 1/2″ Vice – Hold the Frame and Jig

      Glock Vice Block – Hold the frame in the vice

End NipsCut the tabs

Dremel – Trim the tabs

Dremel Reinforced Cut Off Wheel  – Trim the tabs

Drum Sander Set  – Trim the tabs

1911 Locking Lug File – Trim the tail off the rear tabs

    8″ Mill File

Brownells Card File – Used off camera to clean the file

File Handle– Never use a File without a handle for safety purposes

    320 Grit Sand Paper – Smooth Tool Marks out of Frame Rail

Cutting the barrel block with a Dremel

Dremel – Cut the barrel block

Drum Sander Set  – Cut the barrel block

4 1/2″ Vice – Hold the Glock Vice Block

Glock Vice Block – Hold the frame in the vice

    320 Grit Sand Paper – Smooth tool marks

    Diamond Needle File – Hold sandpaper


PF940SC Completion – Drill Press method

Drilling the frame

4 1/2″ Vice – Hold the Frame and Jig

Vice Jaws – Hold the Frame and Jig

Ryobi drill

Hobby Knife – Clean up extra plastic

Milling the frame with a drill press

5 in. Rugged Cast Iron Drill Press Milling Vise – To hold the Frame

Drill Press – Drill the Holes

Dremel – Clean up the tool marks

Drum Sander Set  – Clean up the tool marks

    320 Grit Sand Paper – Smooth tool marks

    Diamond Needle File – Hold sandpaper

Cutting the barrel block with the end mill

5 in. Rugged Cast Iron Drill Press Milling Vise – To hold the Frame

Drill Press – Drill the Holes

Clamp

      Hobby Knife

Dremel – Clean up the tool marks

Drum Sander Set  – Clean up the tool marks

    320 Grit Sand Paper – Smooth tool marks

    Diamond Needle File – Hold sandpaper


Installing the lower parts

Installing the magazine release

Needle Nose Vice Grips

Hook Pick

Installing the rails

Brownells Universal Pistol Armorers Block – (you can use a piece of 2X4 with holes drilled into it as well)

Lyman Tapper Hammer – Drive the Trigger Stop Pin into the Frame

Armorers Tool

Installing the trigger

Lyman Tapper Hammer – Drive the Trigger Stop Pin into the Frame

Armorers Tool

Brownells Universal Pistol Armorers Block – (you can use a piece of 2X4 with holes drilled into it as well)

Installing the takedown

Tweezers – Install Safety Lifter and Sear

Pick – To install the Takedown Safety Lever Spring

 

How to Support Us to Keep Free Content Coming

 

If you like the work that we do here at The Rogue Banshee, please consider supporting us for free by clicking on our affiliate links before purchasing gear, parts and tools or donating to us on Patreon. Your support allows us to continue to produce the quality content that you expect from us. 

 

Don’t forget to spread the word on your favorite Social Media platform by clicking the sharing buttons below.