This page may contain affiliate links. If you click and buy, I may earn a small commission at no extra cost to you. Your purchase using affiliate links helps support the creation of independent content.
Polymer80 PF940SC Dremel Completion
I have been getting interest from people to put up my old content. These methods are outdated and we have worked hard to bring new content over at Freedom Crew University. Check out the master classes from my good buddy Marine Gun Builder over there.
If you want to learn more about the tools used in the PF940SC Videos visit https://trb.fyi/tools-used-in-the-polymer80-pf940sc-completion-videos/. If you need more information about troubleshooting visit our Glock Troubleshooting Guide.
This content shows an older method for completing a Polymer80 PF940SC using a Dremel. While it may still be helpful for historical reference, it does not reflect current best practices or legal considerations.
Looking for current info?
➤ Check out updated PF940SC courses at Freedom Crew University.
➤ See tools used in the original videos: PF940SC Tools List
➤ Need help troubleshooting your build? Read our Glock Troubleshooting Guide
Video index Of the Original Video:
What’s included – 0:16
Basic steps – 0:44
Drilling the frame – 1:12
Cutting the frame – 2:30
Cutting the barrel block – 4:05
Installing the magazine release – 5:33
Installing the rails – 6:29
Installing the trigger – 7:57
Installing the takedown – 10:16
Does it work? – 11:21