5D Tactical article thumbnail
Shop the 5.11 Closeout Locker

5D Tactical – Using the Router Jig Pro

Our 5D Tactical video will show you what comes with the 5D Tactical Multiplatform jig and how to use it.

 

We have an article that we put the 80 Percent Arms Jig against the 5D Tactical Jig. Visit that article at https://trb.fyi/ar-jig-shootout-5d-tactical-vs-80-percent-arms

The lowest advertised price that we found on the Internet is from JSD Supply. Check out the jig here https://bit.ly/373D8aL

Visit us at : 

http://www.trb.fyi
http://www.facebook.com/TheRogueBanshee/
http://www.twitter.com/TheRogueBanshee
http://www.patreon.com/TheRogueBanshee  

Video Index:

What comes with the jig kit – 0:24
Step 1: Installing the buffer adapter – 2:13
Step 2: Mounting the lower to the jig – 3:16
Step 3: Installing the side plates – 5:06
Step 4: Installing the drill guide – 6:20
Step 5: Router setup – 7:02
Step 6: Drilling the pilot hole – 9:07
Step 7: Milling the lower – 10:31
Step 8: Drilling the safety, hammer and trigger pin holes – 13:58
Step 9: Removing the receiver from the jig – 14:59
Does it work – 15:48

Tools:

There are several tools we used in the 5D Tactical video. Below is the list of tools and the links to purchase them. 

When purchasing tools, I try to buy them from Brownells since they have a 100% Satisfaction Guarantee. I have broken roll pin punches that Brownells has replaced with no questions asked. 

I purchased my Jig from JSD Supply. They have the lowest advertised price for the jig that I have found. 

5D Tactical Jig Pro

#2 Roll Pin Holder Punch – Used to tighten the buffer adapter

#2 Philips – Used to install jig screws

Scotch-Brite Sponge – Used to debur the router threads

5″ OAL Needle Nose Pliers – Used to remove the collet on the router

5/8″ Wrench – Used to install mill on the router

7/64″ Allen wrench– Used to change guide pins

Simple Green – Used to clean up the jig and lower

Masking Tape – Used to protect the lower in the jig

Ryobi Drill – Used to drill the pilot, selector, hammer and trigger pin holes

Rigid 24012 Router – To mill out the lower

Oatey 3024 Dark Cutting Oil – To cool and lubricate the mill and drill bits

5 in. Rugged Cast Iron Drill Press Milling Vise – To hold the Frame

 

If you like the work that we do at The Rogue Banshee, please consider supporting us for free by clicking on our affiliate links before purchasing gear, parts and tools, donating to us using the links to the right of this article or becoming a patron on Patreon. Your support helps us produce content as we do not allow vendors or manufacturers to pay us for content. 

Also, don’t forget to share our content on your favorite social media platform by clicking the sharing buttons below. 

Shop the 5.11 Closeout Locker